Â
Pro AV Catalog
Request Quote
All Products
18 Watt 8 ohms Audio Power Amplifier - STICK-ON series module
Series:
Model: ST-PA18
- 18 Watts RMS Audio Power Amplifier
- Output for 8 ohms Speaker
- Maximized Audio Level at Full Power Output
- Superior Audio Quality at High Output Levels
- Line Level Balanced or Unbalanced Input
Product Info
Tech Specs
Documents
Accessories
The ST-PA18 features a balanced line level input that may be connected unbalanced. The gain control range will accommodate standard unbalanced levels as well as professional balanced levels. The module bridges the input signal. LOOP OUT terminals permit a balanced input to be fed to additional amplifier modules making the ST-PA18 an ideal component in distributed audio system design. The LOOP OUT may also be used to feed a subwoofer amplifier (see RDL ST-CX2S Subwoofer Filter). The ST-PA18 output will drive an 8 ohm speaker or multiple speakers connected to present an 8 ohm load to the amplifier and it is capable of driving 4 ohm loads. A red COMP LED is provided to indicate the threshold of the integral compressor. Audio levels that could cause the amplified output to clip are compressed according to two dynamic time constants. Normal audio level signals remain unaffected by the compressor thereby preserving audio dynamics and preventing the compressor from increasing feedback potential when the amplifier is used for paging. The compressor is designed to remain aurally transparent while maintaining clean, unclipped amplified audio for input overloads of up to 20 dB. The ST-PA18 produces average audio levels and audio clarity normally expected of amplifiers delivering much higher output power. The ST-PA18 operates from an external 24 VDC 1A power supply, sold separately. A POWER LED illuminates when the module is powered. The module provides thermal and output short-circuit protection.
- 18 Watts RMS Audio Power Amplifier
- Output for 8 ohms Speaker
- Maximized Audio Level at Full Power Output
- Superior Audio Quality at High Output Levels
- Line Level Balanced or Unbalanced Input
- LOOP OUT to Feed Additional Amplifiers
- Integral Audio Compressor to Control Clipping
- High Overall Audio Operating Level
- Amplifier Signal Type - Audio
- Amplifier Type - Power Amplifier
- Noise: < -75 dB (below 18 W RMS)
- Operating Temperature (Maximum): 86 F
- Operating Temperature (Minimum): 32 F
- Maximum Frequency Response (Bandwidth): 20 kHz
- Maximum Frequency Response (Bandwidth): 20000 Hz
- Minimum Frequency Response (Bandwidth): 20 Hz
- Minimum Frequency Response (Bandwidth): 0.02 kHz
- Total Harmonic Distortion + Noise (THD+N): 1 %
- Inputs: Line level (+4 dBu bal; -10 dBV unbal)
- Input Impedance: 20 K ohm balanced bridging; 10 k ohm unbal
- Gain Adjustment: Single turn
- Minimum Input Levels: -16 dBu balanced; -18 dBV unbalanced
- Maximum Input Levels: +25 dBu balanced; +22 dBV unbalanced
- Compressor Threshold: 3 dB below rated output, automatic adjusting attack and release
- CMRR: > 45 dB (50 Hz to 120 Hz)
- Output Power: 18 W RMS into 8 ohm
- Output Circuit: Class D
- Red LED: LED indicates compressor activity
- Green LED: Power ON
- Power Requirement: 24 VDC @ 1000 mA, Ground referenced
Datasheet for 18 Watt 8 ohm Audio Power Amplifier
231680 kb
- Other
Request Quote
Thank you!
Someone will be in touch with you shortly.
Contact Texolve Digital Inc.
close
Texolve Digital Inc.
201A Ann Street
Oakmont, PA 15139
USA
(724) 337-1685
www.texolve.com
Contact in regards to this product:
Radio Design Labs
Model: ST-PA18
Request more information from a dealer near you
close
Request more information from a dealer near you
Â